Basic Operations; Power On - Motorola MW810 Owner's Manual

Basic Operations

This section describes the following display operations:
•

Power On

•
Power Off
•
CCFL Heater control
•
Standby
•
Wake Up
•
Rotary knob
•
Emergency key
•
Function keys
•
Illumination control
•
Brightness control
•
Touch-screen calibration
NOTE: Proper display functionality can be achieved only if the MW810 Display Control
package is installed. This package is a part of the MW810 CPU software image. When you
use the display with a laptop as the secondary display option, do not forget to install the
display software. Refer to the Display Software chapter in this document for details.
Power On
The display can be turned on either from the CPU box or from the power button located on
the display's front.
The
POWER UP PREFERENCES
turn the display on:
•
USB 5V PRESENCE
•
POWER BUTTON
When
USB 5V PRESENCE = ENABLE
output from the CPU USB controller.
When
POWER BUTTON = ENABLE
display on.
You can select any of above options or use their combination.
Turn on the display and see high-quality picture without image distortions. If you have an
issue, see troubleshooting information in Appendix D.
During power up sequence the device performs Power-On self test. If any of conditions
below is found, the device will not power on.
CAUTION: Critical Temperature Conditions
The device is operational only within valid temperature range. When the internal
temperature (equivalent to ambient) is beyond the operational range, the display will
indicate about operational failure and will not power on.
CAUTION: Discharged Vehicle Battery
The device is operational when the car battery voltage is above the low control limit.
parameter in the display's codeplug provides two options to
- Turn on the front edge of USB 5V CPU output.
- Turn on pressure of the power button on CPU or Display units.
, the CPU will turn the display on by means of USB 5V
, press the CPU or display power button – it will power the
MW810 Display Owner's Manual 21
6802982C85-C