Test Run Procedure - Sanyo Big PACi 18 Series Technical Data & Service Manual

2-24. Test Run Procedure

Recheck the items to check
before the test run.
Check the combination (wiring) of
indoor and outdoor units.
2
YES
(1 indoor unit is connected
Turn ON Are multiple outdoor units
the indoor
and outdoor
power.
(Automatic
Address)
(See 2-26-2) How to Set the Outdoor
Unit System Address
Set the outdoor unit system
address.
(See 2-26-1, -2) How to Set Automatic
Address
Set the automatic address
setting from outside unit.
Indicate (mark) the
combination number.
Set the indoor unit control
unit to "TEST".
Turn the power back ON to
the indoor unit.
(See 2-11)
(See 2-26-1)
Is system "single-type"?
to 1 outdoor unit)
NO
NO
used?
YES
(See 2-26-3, -4)
(See 2-26-3)
Refer to "Table of
NO
Can
Self-Diagnostic
operation be
Functions" to check
started?
the system.
In addition, refer to
2-26 and correct any
items that need to be
corrected.
YES
Note: Check the indoor-
side drainage.
(See 2-13)
Turn ON
the indoor
and outdoor
power.
(Automatic
Address)
(See 2-25)
Fig. 2-22
2-22