Cisco Surge-Gap Drop Amplifier Installation Instructions Manual page 10

Installing the Surge-Gap Drop Amplifier,
Remote Powering
Follow the steps below to install the drop amplifier outside the customer premises.
Note: Outdoor installations require the optional power inserter and water sealing F-
connector boots or shrink tubing.
CAUTION:
Avoid possible shorting of the AC adapter. Make all connections to the drop
amplifier before the AC adapter is plugged into an electrical source.
1. Locate the drop amplifier near the drop cable.
Note: Cisco recommends that you install the drop amplifier inside a network
interface box. However, you can install the drop amplifier in an exposed area
if necessary.
2. Connect the power inserter to the customer equipment drop, locating it near
an AC outlet.
3. Attach the power inserter to the AC adapter, as shown in the diagram in step
4.
Avoid possible electrical shock and damage to customer equipment.
Make sure the power inserter is oriented as shown in the diagram in step
4.
10
WARNING:
Continued
562774 Rev E