Style 2 - Built-In Outdoor Grill Installation - KitchenAid KFRU488TSS Installation Instructions And Use & Care Manual

WARNING
Excessive Weight Hazard
Use two or more people to move and install grill.
Failure to do so can result in back or other injury.
Unpack grill. Remove all packaging materials and remove grill
from carton.
Move grill close to desired outdoor location.
Open the hood.
Remove Packaging Material Inside the Grill
1. Cut the tiedowns holding the grates together.
2. Remove rotisserie skewer (on some models), warming shelf
and grill grates from inside the grill and remove packaging
material.
3. Remove foam block and wrap from inside the grill.
A
A. Foam block
B. Foam wrap
4. Replace the grill grates.
5. Place warming shelf on brackets as shown.
A
A. Warming shelf brackets
B. Warming shelf
6. Install rotisserie mounting bracket using 2 screws.
A
A. 2 bracket screws
B. Rotisserie bracket
7. Dispose of/recycle all packaging material.

Style 2 - Built-in Outdoor Grill Installation

B
B
A
B
Make Gas Connection
NOTE: If grill has been converted to LP gas, follow instructions in
"If Converting to LP Gas" at the end of this section.
WARNING
Fire Hazard
Do not use grill near combustible materials.
Do not store combustible materials near grill.
Doing so can result in death or fire.
Natural Gas Use
This installation must conform with local codes and ordinances.
In the absence of local codes, installations must conform with
either the National Fuel Gas Code ANSI Z223.1 - latest edition, or
CAN/CGA-B149.1 Natural Gas and Propane installation code.
1. Place grill into outdoor enclosure, but leave enough room in
back to connect to gas supply and electrical plug-in.
WARNING
Explosion Hazard
Use a new CSA International approved "outdoor"
gas supply line.
Securely tighten all gas connections.
Failure to do so can result in death, explosion, or fire.
2. Make gas connections.
A combination of pipe fittings must be used to connect the
grill to the existing gas line.
If local codes permit, use an outdoor flexible stainless
steel tubing gas connector, design-certified by CSA
International, to connect the grill to the rigid gas supply
line. A " diameter line is recommended. Using a wrench
to tighten, connect the gas supply to the grill. Use pipe-
joint compound on all non-flared male threads. Do not
kink or damage the flexible connector when moving the
grill.
15