Selecting A Network Connection - Canon XF205 Instruction Manual

Selecting a Network Connection

Selecting a Network Connection
You can save up to 5 different network configuration profiles. You can select which one to use depending on
where you plan to use the camcorder. If you just saved a new network configuration (A 178), that network
180
configuration will already be automatically selected and this procedure is not required.
1 Open the [Select] submenu.
[w Other Functions] > [Network Settings] > [Connection Settings]
> [Select]
2 Select the desired configuration number and then press SET.
• The camcorder will connect to the selected network only when you
activate a network function. The icon displayed on the top left of the
screen will indicate the type of network selected and the connection
status. Refer to the following table.
Connection type
Wi-Fi
(Infrastructure)
Wi-Fi
(Camera Access Point)
LAN (Ethernet)
Onscreen
display
In yellow: The camcorder is connecting to or disconnecting from
the network. In white: The network function can be used.
In yellow: Starting the camcorder's access point. In white: The
camcorder's access point is ready. Connect the Wi-Fi enabled
device to the camcorder.
• On the device: Open the Wi-Fi settings screen and select the
network name (SSID) that was set in the camcorder. If
necessary, enter the password set in the camcorder (A 177).
In yellow: The camcorder is connecting to or disconnecting from
the network. The LAN access indicator will flash as well.
In white: The network function can be used. The LAN access
indicator will illuminate as well.
• If you set [w Other Functions] > [LAN (Ethernet) LED] to [Off],
the LAN access indicator will not illuminate.
Connection status
[w Other Functions]
[Network Settings]
[Connection Settings]
[Select]
Connection type