Setup; Programming - Zenith SM-H-17-4 Service Manual

FLOPPY DISK DRIVE
1
2 - 1
SETUP
INSET
a
a
f}-~-[}-[}-Il-Il-
PART A
L.l.l-l-1-l-j
~
bd
C.l.l-l.J
~';---..J
PROGRAMMING
MODUlE
If this Drive is to be hardware unit 2, cut the pro-
gramming plug as shown in Part C of the Figure.
If this Drive is 10 be hardware unit 0, cut the pro-
gramming plug as shown in ParI A of the Figure.
Ir this Drive is to be hardware unit 1, cui the pra.
gramming plug as shown in Pari 8 of the Figure.
Programming
Refer
10
Figure 2-1 (fold-out from this page) for the
following programming steps.
Tosel up a programming module. you may either cui
the link on the module or bend out the appropriate
leg. The advantage of bending out the leg is that you
may return the module to its original slate.
o
INSET
f}-~-[}-[}-Il-Il-
a
PART B
l,.,.l.,.,.J \H-Hl· l -l-i
~
Cl-1-1-1-1-j
{d
lHl.,.j
~_1.1.1.1.j ~I-t---...J
PROGRAMMING
MODUlE
INSET
a f}-~-[}-[}-Il-Il-
~~"
..
~
PROGRAMMING
MODUlE
PART C
•
Figure 2-1