Table of Contents
Advertisement
Changing the RF Transmission Frequency
The RF remote function may be affected by radio interference, etc. If this happens, you can
change the RF transmission frequency.
To change the RF remote transmission frequency:
1. Open the battery cover on the rear.
After changing remote control's RF frequency, you also must change the receiver's RF recep-
tion frequency.
3. To change the receiver's RF reception frequency.
• Press and hold the RF BAND button (TAPE2/CD2 /MONITOR button) behind the receiver's
front panel door for more than 2 seconds. Each time you do this, the RF reception frequen-
cy switches between RF Band 1 and RF Band 2. Select the same band as the position num-
ber of the remote's RF switch.
Remote Controllable Range
Your LCD remote transmits RF signals to the receiver, and the receiver sends IR signals back
to the remote.
The remote's range is about 20 ft
provided there are no obstacles
(see illustration to right).
The remote transmits an infrared
signal in addition to an RF signal.
When RF operation is not possi-
ble because of radio wave condi-
tions, you can aim the remote
towards the receiver and use it as
a conventional infrared remote
control.
Since the LCD remote uses
infrared signals to control other
A/V components and devices,
aim it towards the respective
unit.
The following factors can maximize the performance of your LCD remote:
1. Position the receiver's RF antenna to achieve maximum RF range.
2. Do not position the receiver near metal (such as heat ducts). Metal can absorb RF signals.
2. Change the RF switch setting.
RF
1
2WAY LCD REMOTE CONTROL UNIT
+
+
-
-
/8
1
1
/7
1
2
3
4
5
6
7
8
9
+10
0
+100
10
11
12
RF REMOTE CONTROL UNIT
RC-R0910
3
2
Hide quick links:
Advertisement
Table of Contents
