Daily Care; Cleaning Materials; Cleaning The Scanner Exterior And Adf Paper Chute; Cleaning The Adf - Fujitsu ScanSnap fi-4110EOX2 Getting Started Manual

6. Daily Care

This chapter describes how to clean ScanSnap! scanner.
WARNING
Fire/Electric Shock
Before you replace clean the scanner, disconnect the
AC adapter to turn off the scanner.

6.1. Cleaning Materials

Cleaning Materials Parts No.
Cleaner F1
CA99501-0013
(Isopropyl alcohol)
Lint-free dry cloth Commercially available one. (*2)
*1) To purchase the cleaning material, contact the FUJITSU
scanner dealer where you purchased the scanner.
*2) Any lint-free cloth can be used.
6.2. Cleaning the Scanner Exterior
and ADF paper Chute
Clean the scanner exterior and ADF paper chute with a dry
cloth moistened with a small amount of neutral detergent
or Cleaner F1.
● Never use paint thinner and other organic
ATTENTION
solvents.
● During cleaning, prevent water or
moisture from getting inside the scanner.
14 |
Remarks
1 bottle
Moisten cloth with this fluid
and wipe the scanner clean.
(*1)
Cloth
Neutral detergent or
Cleaner F1
Paint thinner

6.3. Cleaning the ADF

Clean the ADF with a dry cloth moistened with cleaner F1.
As a guideline, clean the ADF after every 1,000 scans.
Note that this guideline varies according to the type of
document you are scanning. For example, the ADF must
be cleaned more often when scanning photocopied
documents where the toner has not been sufficiently fused
on the paper.
Clean the ADF according to the following procedure
referring to the illustrations.
The glass surface inside the ADF becomes hot during
use of the scanner.
Before you start to clean inside the scanner, disconnect
the AC adapter from the outlet, and wait at least 15
minutes for the scanner to cool down.
1. Open out the ADF while lifting up the cover open
lever.
ADF
2. Clean the following locations with a cloth moistened
with Cleaner F1.
Pick arm
Pick spring
Feed rollers
Paper guide
surface
(white part)
(also located
on ADF side)
Cover open lever
Pad ASSY
Plastic
rollers
Pick roller
Exit roller
ADF glass
surface
(also located
on ADF side)