Washing Machine Instruction Manual WD11KD's INSTRUCTION MANUAL ■ Economic wash system Using artificial intelligence, the washer uses minimum energy and water by selecting optimal water level and washing time. ■ Low noise system The washer minimizes the washing and spinning noises by sensing the amount of laundry.
A NOTE TO YOU Thank you for buying a CAMPOMATIC appliance. CAMPOMATIC washers are easy to use, save time, and help you manage your home better. This manual contains valuable information about how to operate and maintain your washer properly and safely.
El Parts and features The parts and features of your washer are illustrated on the page. Become familiar with all parts and features before using your washer. NOTE The drawings in the book may vary from your washer model. They are designed to show the different features of all models coverd by this book. Your model may not include all features.
Washer & Dryer safety Save these instructions Your safety is important to us. To reduce the risk of fire, electrical shock, or injury when using your washer adhere to the following basic precautions. Read all instructions before using your washer •...
Page 5
El Washer & Dryer safety (cont.) Understanding your responsibilities (cont.) • Fabric softeners, or similar products, should be used as specified by the fabric softener instructions. • The final part of a tumble dryer cycle occurs without heat (cool down cycle) to ensure that the items are left at a temperature that ensures that the items will not be damaged.
Inlstallation instructions Removing transit bolts 1. Before operating the washer, remove the transit 2. Unscrew the 4 bolts with the 10mm hex wrench bolts(4ea) along with the rubber. or spanner or cross-tip screwdriver. Keep the 4 • If the bolts are not removed, it may cause bolts for a later time.
Inlet hose connection The washer should be connected to the water mains using new hose sets and old hose sets should not be reused. In using only one water tap or in case of only one water inlet valve, connect the inlet hose to the cold water inlet valve.
Electrical requirements Electrical shock hazard Failure to follow these instructions could result in death or serious injury. WARNING • Electrical earth is required on this washer • Don’t earth to a gas pipe. • If it does not fit the outlet, have a proper outlet •...
Electrical requirements (cont.) Adjust the level of washer using adjustable legs. • Please check if there is any gap between the four adjustable legs and the floor. • Adjust the level of washer by turning adjustable legs. And make it sure that there is no swaying of washer.
Operating your washer (cont.) Sorting • Separate heavily soiled items from lightly soiled ones, even if they would normally be washed together. • Separate dark colors from light colors, colorfast items from non-colorfast item. Soil (Heavy, Normal, Light) Separate clothes according to amount of soil. Color (White, Lights, Darks) Separate white clothes from colored clothes.
The functions of the control panel ■ WD11KD's Press this switch to turn the power on or off. Operation and temporary stop is repeated as it is pressed. When you want to change program in operating; press the “Start/Pause” button → Select the program that you want to change →...
Washing procedure and program selection 1. Cotton is automatically selected upon power on • Press the Power button to start. • Press the Start/Hold button • Initial condition - Program : Cotton - Wash : main wash - Rinse : 3 times - Water temperature : 40°C 2.
Page 13
Washing procedure and program selection 4. FUNCTION • Recommended programs according to the laundry type Fabric Proper Maximum Program Option Type Temp. Load First check if laundry is machine 60°C Pre Wash (Cold, 30°C, washable.(white cotton, linen Rating Rinse+ 40°C, 95°C) towel and sheets..) Cotton/Normal Colorfast garments...
Page 14
Washing procedure and program selection (cont.) * COTTON/NORMAL PROGRAM Put the laundry in to the drum. Put detergent and softener into the detergent case. Then close the door. • Put detergent into the main wash and prewash compartments in the detergent case. Softener should be below the ‘MAX’...
Page 15
Washing procedure and program selection (cont.) * SYNTHETIC PROGRAM Put the laundry in the drum. Put detergent and softener into the detergent case. Then close the door. • Put detergent into the main wash and prewash compartments in the detergent case. Softener should be below the ‘MAX’...
Page 16
Washing procedure and program selection (cont.) * DELICATE / HANDWASH / WOOL PROGRAM Put the laundry in the drum. Put detergent and softener into the detergent case. Then close the door. • Put detergent into the main wash compartments in the detergent case. Softener should be below the ‘MAX’...
Page 17
Washing procedure and program selection (cont.) * INTENSIVE PROGRAM Put the laundry in the drum. Put detergent and softener into the detergent case. Then close the door. • Put detergent into the main wash and prewash compartments in the detergent case. Softener should be below the ‘MAX’...
Page 18
Washing procedure and program selection (cont.) * QUICK 20 Put the laundry in the drum. Put detergent and softener into the detergent case. Then close the door. • Put detergent into the main wash compartments in the detergent case. Softener should be below the ‘MAX’...
Page 19
Washing procedure and program selection (cont.) * SPORTS WEAR PROGRAM Put the laundry in the drum. Put detergent and softener into the detergent case. Then close the door. • Put detergent into the main wash and prewash compartments in the detergent case. Softener should be below the ‘MAX’...
Page 20
Washing procedure and program selection (cont.) * TUB CLEAN PROGRAM Press the Power button. • The LED shows only ‘---’ signal. Select the ‘Tub Clean’ program using program selection dial. • ‘Soak’ and spin ‘400’ rpm and ‘Cold’ water temperature. Press Start/Pause button.
Page 21
Washing procedure and program selection (cont.) * DRAIN PROGRAM Press the Power button. • The LED shows only ‘---’ signal. Select the ‘Drain’ program using program selection dial. Press Start/Pause button. • Drain program will start. NOTE • All programs are not selectable. E-21 E-21...
Guide for other useful programs * DELAY START(RESERVED WASHING) Put the laundry into the Drum and put the detergent and softerner into the detergent case. Then close the Door. • Put the detergent into the main wash room(I I marking) and prewash room(I marking) in the detergent case.
Page 23
Guide for other useful programs * MEMORY PROGRAM Put the laundry into the Drum and put the detergent and softerner into the detergent case. Then close the Door. • Put the detergent into the main wash room(I I marking) . •...
Page 24
Guide for other useful programs (cont.) * ONLY WASH Put the laundry into the Drum and put the detergent and softerner into the detergent case. Then close the Door. Press the Power button. • The LED shows only ‘- --' signal. Select the ‘WASH COURSE' you want by pressing ‘Wash' button.
Page 25
Guide for other useful programs (cont.) * DRY Put the laundry into the Drum and close the Door. Press the Power button. • The LED shows only ‘- --' signal. Select the ‘DRY CONDITION' you want by pressing ‘DRY' button. As this button is pressed, the dry condition is selected by ‘Cupboard' →...
Page 26
Guide for other useful programs (cont.) * CHILD LOCK Press the "Wash" and "Temp." button simultaneously during processing. Under the Child Lock function, only power button is working. During Child Lock function, CHL will be displayed on '18:88'. In order to unlock Child Lock mode, press "Wash" and "Temp." simultaneously. E-26 E-26...
Maintenance Proper care of your washer can extend its life. This section explains how to care for your washer properly and safely. Cleaning your washer Exterior Interior Wipe up detergent, bleach, and other spills with a Clean interior with 250ml of chlorine bleach soft, damp cloth or sponge as they occur.
How to clean the filter Lint Filter Filter Frame Filter Frame Lint Filter Lint Filter Filter Frame Cleaning the water inlet filter Clean the filter when water leaks from the water inlet. Pull the power plug Turn off the water Pull the inlet filter out.
Removing stains Stained, heavily-soiled, or greasy items may need to be prewashed or soaked for best results. Soaking helps remove protein-type stains like blood, milk or grass. Prewashing helps loosen soil before washing. Stain removal rules • Use warm water for soaking or prewashing stained laundry. Hot water can set stains. •...
Trouble shooting Most problems are easily solved if you understand the cause. Check the following list for problem before calling for service. If the error mode such as IE, OE, UE were displayed on the control part, in order to solve these problem, first turn off the power of the washing machine and then turn on the power pressing Power button.
Specification WD11KD's MODEL Dimension (mm) 600 X 645 X 850 Spin Speed (RPM) MAX 1400 0.03MPa ~ 0.8MPa (0.3kgf/cm² ~ 8kgf/cm²) Operating Water Pressure Wiring diagram DWC-LD'S (OPTION) (OPTION) (OPTION) DWD-LD'S E-31 E-31...
Page 32
کیفیة تنظیف الفلتر ter Frame Lint Filter Filter Frame Lint Filter Filter Frame FILTER FILTER FILTER CASE CASE CONTAINER CONTAINER FILTER FILTER about about 13~14cm 13~14cm about about 13~14cm 13~14cm CASE CASE CASE GUIDE GUIDE GUIDE FILTER FILTER SUIT SUIT SUIT...