Removing Misfeeds; Original Misfeed In The Rspf - Sharp MX-M200D Operation Manual

REMOVING MISFEEDS

When a misfeed occurs during copying, the message "
Check the location and remove the misfeed.
The paper may tear when you remove a misfeed. In this event, be sure to remove all torn pieces of paper from
Note
the machine, taking care not to touch the photoconductive drum (the green part). Any scratches or damage to the
surface of the drum will cause dirty copies.
First check the misfeed location.
(Page 31)
(Page 33)
(Page 34)

ORIGINAL MISFEED IN THE RSPF

1
Remove the misfed original.
Section A
Open the feeding roller cover and remove the
misfed original from the document feeder tray.
Close the feeding roller cover.
Feeding roller cover
(See below)
(Page 31)
(Page 30)
(Page 34)
Check sections A, B, and
C in the left shows the
illustration (see the next
page), and remove the
misfed original.
Clear paper path." and the location of the misfeed will appear.
Misfeed locations in the optional
2 x 250-sheet paper feed unit
(Page 34)
(Page 34)
Section B
Open the RSPF and rotate the two release
rollers in the direction of the arrow to feed the
original out. Close the RSPF and then remove
the original.
If the original misfeed occurred in the right roller,
open the automatic document feeder and rotate
the right release roller in the direction of the
arrow to remove the original.
If a small original (5-1/2" x 8-1/2", etc.) is misfed,
open the right side cover and remove the
original. Close the right side cover.
Right side cover
(Page 34)
(Page 34)
2
Roller
29