Mono (Bridged, Or Btl) Configuration - Kenwood KMF-X9000 Instruction Manual

7

Mono (bridged, or BTL) configuration

In this configuration, the KMF-X9000's two individual channels operate together to drive a single speaker (such as a subwoofer) in
mono. This allows the amplifier to deliver more than double the power of one of its channels to the speaker.
1
Make sure that the KMF-X9000's power cord is unplugged from the wall outlet before making any connections.
2
According to the speakers to be used, set the speaker impedance selector switch as follows:
• For 6-16 Ω speakers: Set the 2Ω (STEREO)/6Ω OVER switch to 6Ω OVER and 6Ω OVER/2Ω switch to 2Ω.
3
Connect the amplifier as shown in the diagram.
• Make sure to connect the audio input cable to the MONO/BTL input.
Except for Europe
Note: Since bridged operation produces enough output power to pose a small risk of electrical shock from the speaker termi-
nals, please attach the terminal cover as shown in the diagram below:
KRF-X9995D
When a monaural
pre-out signal is to
be connected, be
sure to connect it to
the MONO/BTL
terminal.
Now you can plug the power cord of this unit into the AC outlet!
CAUTION:
Before reconnecting a speaker cord or switching a selector switch, turn OFF the power and unplug the power
cord to avoid malfunctions or damage to the unit.
DTS-ES
SURROUND CD 2 / TAPE 2 CLIP
DISCRETE 6.1 MATRIX 6.1 NEO : 6 PRO LOGIC BACK 96kfs MONITOR INDICATOR
Audio cord (not supplied)
Stereo mini-plug cord (supplied)
For 12 V RELAY CONTROL, see page 6.
Except for Europe
Mount the supplied
speaker terminal cover
using the two screws that
Subwoofers are attached to the unit.
(6Ω-16Ω)
To wall AC
outlet
5
EN