Advertisement
4) If using USB, verify that the correct operating system driver is loaded on your computer. Try reloading
the driver, or try unplugging the receiver, waiting 10 seconds, and then plugging it back in.
"The LED on the remote flashes or does not turn on when I push the advance or reverse button, or
the laser pointer is dim or does not work when the laser button is pushed."
1) The battery is dead. Replace the battery.
Limited Warranty
Street Smart Technologies, a Division of Honeywell Home and Building Control, ("Seller"), 13475
Danielson St. Suite#120, Poway California 92064, warrants its product to be in conformance with its own
plans and specifications and to be free from defects in material and workmanship under normal use and
service for 12 months from the date of original purchase.
Seller's obligation shall be limited to repairing or replacing, at its option, free of charge for materials or
labor, any product that is proved not in compliance with Seller's specifications or proves defective in
materials or workmanship under normal use and service. Seller shall have no obligation under this Limited
Warranty or otherwise if the product is altered or improperly repaired or serviced by anyone other than
Street Smart Technologies. When returning a product, a Return Material Authorization number (RMA#) is
required and must be obtained from Street Smart Technologies. The RMA# must be clearly displayed on
the outside of the shipping carton and the product must be accompanied by documentation that explains the
problem and provides proof of date of purchase.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interferences that may cause undesired operation.
FCC ID: Transmitter: KFR-LSRTS Receiver: KRF-LSRRS
Federal Communications Commission (FCC) Statement
This equipment has been tested to FCC requirements and has been found acceptable for use.
The FCC requires the following statement for your information:
This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in
strict accordance with the manufacturer's instructions, may cause interference to radio and television
reception. It has been type tested and found to comply with the limits for a Class B computing device in
accordance with the specifications in Part 15 of FCC Rules, which are designed to provide reasonable
protection against such interference in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause interferences to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• If using an indoor antenna, have a quality outdoor antenna installed.
• Reorient the receiving antenna until interference is reduced or eliminated
• Move the receiver away from the control/communicator.
• Move the antenna leads away from any wire runs to the control/communicator.
• Plug the control/communicator into a different outlet so that it and the receiver are on different branch
circuits. If necessary, the user should consult the dealer or an experienced radio/television technician for
additional suggestions. The user or installer may find the following booklets prepared by the Federal
Communications Commission helpful:
"Interference Handbook" This booklet is available from the U.S. Government Printing Office, Washington,
DC 20402. The user shall not make any changes or modifications to the equipment unless authorized by the
installation instructions or User's Manual. Unauthorized changes or modifications could void the user's
authority to operate the equipment.
Honeywell
13475 Danielson St. Suite#120
Poway, CA 92064
(858) 513-6391
www.powerremote.com
Advertisement
