• Reorient or relocate the receiving antenna power back on. • Increase the separation between the equipment If the problem persists, consult your Kenwood dealer. and receiver • Connect the equipment into an outlet on a FCC Warning...
Do not use hard cloths or paint thinner, alcohol, or other volatile solvents to clean the unit. These may cause damage or remove indicator characters. Warning Do not operate the unit in a way that might divert your attention from driving safely. As a driver, you alone are responsible for safely operating your Base nut vehicle in accordance with traffic safety laws at...
Everywhere’s front panel. in wiring to your vehicle’s electrical system. • If using screws, be sure that you do not damage Kenwood recommends having an audio installer wiring or other systems that may be close to the professional perform this step.
3. Route the cable from Note: KENWOOD RECOMMENDS UNPLUGGING THE the lowest point of CIGARETTE LIGHTER ADAPTER AFTER YOU TURN OFF the rear window into THE VEHICLE’S IGNITION. (In some vehicles, the the trunk. Take cigarette lighter remains active after the ignition...
The second-best antenna location is on an The location of the “X” on the map must be visible to the antenna. outside wall. • Place the antenna midway between the left and • Select an appropriate wall, depending on where right window frames.
Subscription Before you can listen to Here Everywhere, you must subscribe to SIRIUS Satellite Radio’s service. Note: You can activate your SIRIUS subscription from either the car docking cradle or from the home docking cradle. Once it is activated in one, it will work in the other, provided the antenna has a clear view to the sky.
Note: If the display reads, “Updating Channels, ” the you. (You can also contact SIRIUS on the Internet at: www.siriusradio.com and click on receiver is getting the latest channel listing from the the “Activate” link.) SIRIUS satellites. Give it 5 minutes to complete before moving to the next step.
Page 10
play. (You also do this by pressing the CH buttons locked, the display will read “No Channels on the remote.) The name and artist of the currently- Available” when that category is highlighted. playing song will scroll across the display. If you (See Add/Skip Channels Option on pg.
and hold the Control Knob for 2 seconds on the 2. Select the channel you want to preset (see Basic front panel (or press the Back button on the Operation and Selecting Channels, pg. 17). remote) to exit the mode and return to the Default 3.
Recalling and Managing To activate S-Seek, press and hold the S-Seek (Memo) button, and the first song in memory will Music Information be displayed. Use the Control Knob (or the remote You can see the songs you’ve stored using the CH buttons) to scroll through the saved songs in Memo button.
SIRIUS ID Menu Option the Control Knob to save the change. Press the Menu button to cancel changes and return to the When you select this option, the unit’s unique previous menu. 12-digit SIRIUS ID Number will be displayed: Auto Dimmer This is an on/off setting.
Kenwood recommends leaving this at the factory default level unless it is necessary to change it. The most common use for this setting is to adjust headphone volume levels if you are using Everywhere is turned off.
Time Features The following options appear in this submenu: • Format This menu option allows you to control the clock, • Time Zone alarm, program alerts, and other features that use • Daylight Savings Time Here Everywhere’s internal clock. Pressing the Select button enters the selected sub- Here Everywhere has an internal clock which auto- menu.
Turn the unit’s power off; remove it from the dock; wait 5-10 seconds; replace it in the dock and turn power back on If the problem persists, consult your Kenwood dealer Move antenna to a window with a non-metallic screen...