The Wps Screen - ZyXEL Communications VMG892-B10A User Manual

6.5 The WPS Screen

Use this screen to configure WiFi Protected Setup (WPS) on your Device.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See
Note: The Device applies the security settings of the SSID1 profile (see
page
mode of SSID1 to WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click
Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
Figure 41 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 23 Network Setting > Wireless > WPS
LABEL
WPS
Method 1
Connect
Method 2
VMG8924-B10A and VMG8924-B30A Series User's Guide
Section 6.10.9.3 on page 102
74). If you want to use the WPS feature, make sure you have set the security
DESCRIPTION
Select Disabled to deactivate WPS on the Device. Otherwise, keep Disabled unselected.
Use this section to set up a WPS wireless network using Push Button Configuration (PBC).
Click this button to add another WPS-enabled wireless device (within wireless range of the
Device) to your wireless network. This button may either be a physical button on the
outside of device, or a menu button similar to the Connect button on this screen.
Note: You must press the other wireless device's WPS button within two minutes of pressing
this button.
Use this section to set up a WPS wireless network by entering the PIN of the client into the
Device.
Chapter 6 Wireless
for more information about WPS.
Section 6.2 on
87