Connecting Wires To Terminals - Kenwood KDV-C810 Instruction Manual

Connecting Wires to Terminals

■ Power wire connection
2 CAUTION
Caution on power wire connection
• Be sure that the ground wire is connected to the chassis of a vehicle.
• Connect to another component after having connected the power/ground wire.
• If connecting to a center unit, you must connect the power/ground wire of this unit.
H
45°
V
45°
V
Picture format selector
switch
Select the NTSC/PAL
position for your monitor.
PAL
Please follow the procedure below to switch the NTSC/PAL switch.
1. Remove the magazine.
2. Turn OFF the power.
3. Set the switch to "NTSC" or "PAL".
4. Turn ON the power.
5. Insert the magazine.
If the magazine is inserted before the power is turned ON, the picture may not
be displayed correctly until the disc is played.
Fuse (2A)
Ignition wire (Red) 7
Fuse (5A)
Battery wire (Yellow) 6
Ground wire (Black) - (To car chassis)
H
NTSC
13
ACC
13
BATT
48
Connection wire (Green)
(Accessory5)
PARKING
To parking brake detection switch
harness of car
2 CAUTION
For the sake of safety, be sure to
connect the parking sensor.
Light detector of remote
controller (Accessory8)
— 30 —
Ignition key
switch 41
ACC 44
Car fuse
Car fuse box 45
box
(Main fuse)
42
– +
Battery
43