Connecting Wires To Terminals - Kenwood KDC-215S Instruction Manual

Connecting Wires to Terminals

KENWOOD disc changer control input (KDC-4015/415S/315V/315S/35MR only)
FM/AM antenna input
Connect either to the power control terminal
when using the optional power amplifier, or to
the antenna control terminal in the vehicle.
Ignition key
switch
Car fuse box
(Main fuse)
–
+
Battery
2WARNING
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those wires
to the power source running through the fuse box.
NOTE
To connect the Disc changer,
consult your Disc changer manual.
If no connections are made, do not let the
wire come out from the tab.
P.CONT.OUT
ANT.
CONT.
ACC
Car fuse
box
Ground wire (Black) · (To car chassis)
Fuse (10A)
Wiring harness
(Accessory1)
Power control/Motor antenna
control wire (Blue/White)
Ignition wire (Red)
Battery wire (Yellow)
2CAUTION
When only two speakers are being connected to the system,
connect the connectors either to both the front output
terminals or to both the rear output terminals (do not mix
front and rear). For example, if you connect the + connector
of the left speaker to a front output terminal, do not connect
the - connector to a rear output terminal.
— 20 —
Rear left output (White)
Front left output (White)
(KDC-4015/415S only)
Front right output (Red)
(KDC-4015/415S only)
Rear right output (Red)
White/Black
–
To front left
speaker
+
FRONT • L
White
Gray/Black
–
To front right
speaker
+
FRONT • R
Gray
Green/Black
–
To rear left
speaker
REAR • L +
Green
Purple/Black
–
To rear right
speaker
REAR • R +
Purple