Setting Central Addresses, Unit Names And Tenant Numbers; Main Sub; Entering Text And Numbers - Panasonic CZ-256ESMC2 Operation Manual

Centralized control system intelligent controller
Hide thumbs Also See for CZ-256ESMC2:
Table of Contents

Advertisement

6 Using the System

6.3.3 Setting central addresses, unit names and tenant numbers

Use this screen to set central addresses, names of units connected to the system and tenant
numbers.
Procedure
Select 5.Initial settings in the main menu and 2.CNTR/Unit/Ten. No. in the sub menu, then
proceed as follows.
1.Status/Control
2.Total data/Cut-off
1.Date/Distrib.
3.Distrib. ratio/Usage
2.CNTR/Unit/Ten. No.
4.Maintenance/Test Run
3.Ten. name/Distrib. Gr.
5.Initial settings
4.Pulse meter setting
6.Auxiliary settings
5.Clear accum. data
1
2
3
1 When you touch a central address column, a screen will be displayed as shown on the right.
Input a number 1 to 64 to set central address.
When you touch [Auto], the central address will be automatically set.
Two identical central address settings cannot be used within a link system. If you input an existing
address, the input data is cancelled.
It may take several minutes before the central address settings are re ected in the display.
When other central controllers (system controller, etc.) are connected, it is recommended to set the
central addresses on those units.
24
5
2
5
2
6 Using the System
Main
Sub
2 Touch an unit name column. A keyboard window like the one shown below appears.
Use the keyboard to enter an unit name. Unit names can be up to 12 characters long.
* See "7 Entering Text and Numbers" for details about entering text in keyboard windows.
* You can copy and paste text using the [Copy] and [Paste] buttons. See "7.2 Entering Text" for details.
3 Touch a tenant number.A keyboard window like the one shown below appears. Use the
keyboard to enter the tenant number.
* The tenant number range is from 1 to 256.
5
5
2
2
Main
Sub
25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents