NEC DT20 User Manual page 40

12
Remote Control Operation
P in P
NOTE
• The P in P button is only enabled when a personal computer is selected. You can not use it when video is
selected.
• You can not use the picture in picture function if the signal from the personal computer is not being input.
13
Main Unit Operation
MUTE
Remote Control Operation
MUTE
NOTE
After the projected image has been muted for a certain amount of time (about 15 minutes) it automatically goes
into standby.
Display images from the personal computer
and the video at the same time.
If you select personal computer input while a video source and a
personal computer are both connected, you can display video
images in the window at the lower right side of the projected image.
Set "Picture in Picture" to "ON" on the quick menu to display
video images. See page E-51 for details.
Mute the image.
Press the MUTE button to stop projecting the image without
turning off the lamp. You can select the image projected while
the image is muted from the following two images.
q Project a completely black image while the projected image
is muted.
Set "Black" in "Mute mode" on the "Setting 2" menu (page
E-45). While the image is muted, the projecting black image
icon is displayed on the top right side of the projected
image.
w Project an arbitrary image while the projected image is
muted.
Set "logo" in "Mute mode" on the "Setting 2" menu (page E-
45).
While the image is muted, the projecting image
displayed on the top right side of the projected image.
E-40
icon is