Related Manuals for Raytheon ST80
Summary of Contents for Raytheon ST80
- Page 1 Distributed by Any reference to Raytheon or RTN in this manual should be interpreted as Raymarine. The names Raytheon and RTN are owned by the Raytheon Company.
- Page 2 Chapter 2: Installation ST80 Autopilot Keypad Operation Manual a u t o p i l o t...
-
Page 4: Package Contents
ST80 Autopilot Keypad Operation Manual Package Contents 1. Autopilot keypad 2. Thumb nuts (2) 3. Threaded fixing studs (2) 4. White sun cover 5. SeaTalk cable 6. Installation template 7. Operation manual 8. Warranty card 9. Operation cue card 10. Keypad installation guide... -
Page 5: Table Of Contents
ST80 Autopilot Keypad Operation Manual Contents Chapter 1: Introduction .............. 3 1 . 1 I n t r o d u c t i o n ..............3 Chapter 2: Operation .............. -
Page 6: Chapter 1: Introduction
ST80 Autopilot Keypad Operation Manual Chapter 1: Introduction 1.1 Introduction The Autopilot keypad provides autopilot control via a simple nine- key interface. There are buttons for engaging and disengaging the pilot (auto and standby), course adjustment (-1, +1, -10 and +10), track control, response and direct entry to the autopilot display’s of a... -
Page 7: Chapter 2: Operation
ST80 Autopilot Keypad Operation Manual Chapter 2: Operation 2.1 Keypad Layout and Features The autopilot keypad has been designed as a control interface for Autohelm autopilot’s. The keypad consists of nine push-button keys together with operation status LED’s. The basic function of each of these keys is described in the following illustration. -
Page 8: Basic Operating Principles And Hints
ST80 Autopilot Keypad Operation Manual • When the system is switched on the autopilot is always in STANDBY mode. • The display and lamp key only cycles pilot pages when the pilot chapter is open. 2.2 Basic Operating Principles and Hints... -
Page 9: Track Advance/Acceptance
ST80 Autopilot Keypad Operation Manual Track Advance/Acceptance If your navigation receiver is transmitting waypoint number and bearing to waypoint, a waypoint alarm will sound whenever a new target waypoint is selected. The autopilot maintains the current heading and automatic track control is suspended. Check the new bearing to waypoint, make sure that it is safe to turn, and then return to automatic track control by simply pressing the track key. -
Page 10: Additional Autopilot Features For Sailing Vessels
ST80 Autopilot Keypad Operation Manual 2.3 Additional Autopilot Features for Sailing Vessels Autotack When the autopilot is in compass or windvane mode, the following key command selects autotack mode. Press these keys together momentarily to begin a tack turning to port. -
Page 11: Keypad Illumination
ST80 Autopilot Keypad Operation Manual In gusty conditions, always sail a few degrees off of the wind and pay frequent attention to sail trim and helm balance, using the rudder angle display on a Masterview display head. Generally speaking, performance will be improved by reefing the headsail and mainsail a little early rather than too late. -
Page 12: Important Safety Information
ST80 Autopilot Keypad Operation Manual 2.6 Important Safety Information The following rules should ALWAYS be observed when passage making under autopilot control: Maintain a permanent watch and regularly check all around for other vessels and obstacles – no matter how clear the sea may appear to be, dangerous situations can develop in minutes. -
Page 13: Chapter 3: Emc And Servicing Guidelines
ST80 Autopilot Keypad Operation Manual Chapter 3: EMC and Servicing Guidelines 3.1 Important information All Autohelm equipment and accessories are designed to the best industry standards for use in the leisure marine environment. Their design and manufacture conforms to the appropriate... -
Page 14: Check Before Going To Sea
ST80 Autopilot Keypad Operation Manual 3.3 Check Before Going to Sea • Always check the installation before going to sea to make sure that it is not affected by radio transmissions, engine starting etc.. • In some installations, it may not be possible to prevent the equipment from being affected by external influences. -
Page 15: Chapter 4: Specification
ST80 Autopilot Keypad Operation Manual Chapter 4: Specification Dimensions: 110 x 68 x 17mm (4.33 x 2.67 x 0.66in) Power supply: 10 to 16V DC Current consumption: Less than 240mA with illumination fully on, and less than 90mA at the courtesy level. - Page 17 ST80 Navigator Keypad Installation and Operation Handbook Raytheon Marine Europe Ltd. Anchorage Park, Portsmouth, P03 5TD, England. Telephone: (44) 1705 693611 Fax: (44) 1705 694642...