Cycle And Option Descriptions - KitchenAid W10656164B User Instructions

Table of Contents

Advertisement

Available languages

Available languages

Select a Cycle
See "Cycle and Option Descriptions" charts in the following
section.
Efficient dishwashers run longer to save water and energy, just as
driving a car slower saves on gas. Typical cycle time is
approximately 2 hours, but can take less or more time to complete
depending on selections.
Select Options
See "Cycle and Option Descriptions" charts in the following
section.
You can customize your cycles by pressing the options desired. If
you change your mind, press the option again to turn off the option.
Not all options are available for every cycle. If an invalid option is
selected for a given cycle, the lights will flash.
CYCLE SELECTIONS
The most advanced and versatile cycle. ProWash™
cycle senses the load size, soil amount, and toughness
of soil, to adjust the cycle for optimal cleaning using only
the amount of water and energy needed.
Use for hard-to-clean, heavily soiled pots, pans,
casseroles, and tableware.
This cycle with only the ProDry™ option selected, and
without other options selected, is recommended to
completely wash and dry a full load of normally soiled
dishes. The energy usage label is based on this cycle
and option combination.
Use for lightly soiled items or china and crystal.
When you need fast results, the Express Wash will clean
dishes using slightly more water and energy. Select the
ProDry™ option to speed drying times.
Use for rinsing dishes, glasses, and silverware that will
not be washed right away.
Do not use detergent.
Wash times depend on water temperature, heavy soil condition, dish load size and options selected. Adding options will add time to the
cycle.
*Adding options will add time to the cycle. See options information section.
** This the approximate cycle time obtained with 120°F (49°C) hot water available at the dishwasher. Increase in time results from low
temperature of the incoming water.
8
STEP 3

Cycle and Option Descriptions

CYCLES
Start or Resume a Cycle
Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water.
Press START/RESUME once to show which
selections you used. Select the wash cycle and
options desired OR press START/RESUME to
repeat the same cycle and options as in the
previous wash cycle.
IMPORTANT: If anyone opens the door (such as, for
adding a dish, even during the Delay Hours option), the Start/
Resume button must be pressed each time.
If the Start/Resume button is located on top of door, push door
firmly closed within 3 seconds of pressing START/RESUME. If
the door is not closed within 3 seconds, the Start/Resume
button LED will flash, an audible tone will be heard, and the
cycle will not start.
SOIL LEVEL
WASH TIME* (MINS.)
Typical**
Light to Medium
85
Tough/Baked-On
120
Heavy
120
Heavy/Baked-On
120
Light to Medium
80
Heavy
120
Light to Medium
80
Heavy
120
All soil levels
60
All soil levels
16
STEP 4
WATER
W/O OPTIONS
USAGE
GALLONS
Max
(Liters)
150
3.7 (14.0)
180
4.2 (15.9)
180
4.2 (15.9)
180
4.2 (15.9)
145
2.7 (10.2)
180
4.2 (15.9)
145
2.7 (10.2)
180
4.2 (15.9)
60
5.2 (19.8)
16
2.1 (8.1)

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Dishwasher

Table of Contents