Mode Selection - Sharp VC-H680X Operation Manual

Mode Selection

You can set the basic functions listed in the table below on the
PREPARATION
CHANNEL PRESET
[Blue
[Auto
[Just
. .A--
SE1
press v.
(For details, see Colour Mode on page 20.)
AUTO ..,... Usually select AUTO mode.
P A L Strict PAL colour mode.
NTSC Strict NTSC colour mode.
Select the NTSC mode with the q/b buttons and press
the v button.
NTSC 3.58 When using NTSC 3.58 TV system format. (Input signal:
NTSC 4.43 When using NTSC 4.43 TV system format. (Input signal
PAL TV .., When using PAL TV system format. (Input slgnal: NTSC 4.43)
press v.
AUTO Usually select AUTO.
A blue screen will appear when your VCR receives no TV signal or an
unrecorded tape is played back.
OFF ,, ,,,,.,.., Select OFF if the screen turns blue due to weak TV signal reception, or
playback of a poorly recorded tape.
then press v.
(For details, see Auto Rental Mode on page 21.)
press v.
(For details, see Auto Repeat on page 34.)
press v.
(For details, see Intelligent Timer Recording (JUST
REC) on page 32.)
seieciion scceeii.
NTSC 3.58)
NTSC 4.43)
17