34.2.2 Using the FTP Command from the Command Line
1 Launch the FTP client on your computer.
2 Enter "open", followed by a space and the IP address of your Prestige.
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is "1234").
5 Enter "bin" to set transfer mode to binary.
6 Use "get" to transfer files from the Prestige to the computer, for example, "get rom-0
config.rom" transfers the configuration file on the Prestige to your computer and renames
it "config.rom". See earlier in this chapter for more information on filename conventions.
7 Enter "quit" to exit the ftp prompt.
34.2.3 Example of FTP Commands from the Command Line
Figure 221 FTP Session Example
34.2.4 GUI-based FTP Clients
The following table describes some of the commands that you may see in GUI-based FTP
clients.
Table 149 General Commands for GUI-based FTP Clients
COMMAND
Host Address
Login Type
Transfer Type
Initial Remote Directory
Initial Local Directory
Chapter 34 Firmware and Configuration File Maintenance
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
DESCRIPTION
Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to the
server for anonymous access. Anonymous logins will work only if your ISP
or service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode.
Configuration and firmware files should be transferred in binary mode.
Specify the default remote directory (path).
Specify the default local directory (path).
P-334WT User's Guide
357