Call Forward Off; User Ras Pin; Email Reporting; Email Address - Bosch Solution 144 User Manual

Solution 144 User Guide
Call Forward On
*61,*20#
Press

2. Using the numeric keys, enter all the digits of the
call forward on sequence.
You can change a single digit by scrolling the cursor
left [] and right []. For special characters (eg. , =
pause * or # etc), use the [] and [] keys.
3. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Comms > Telephone Number >

Call Forward Off

When you enter your premises, you no longer need to
remember to manually deactivate the Call Forward feature
via the telephone. These addresses allow you to program
the Call Forward Off sequence that the control panel will
automatically use to un-divert your phone when you turn
Area 1 'Off' .
In Australia, a typical sequence of activating the Call
Forward Off feature is described below:
For other countries please substitute the appropriate
commands after consultation with your telephone company.
Enter programming mode (PIN + MENU) then,
1. #61 (To turn Auto-Forward After Time - Off).
2. # (End of Call-Forward sequence).
Therefore, you would program as per the following steps to
program the call forward on number as: #61#.
1. Enter [MENU] + [5] + [1] + [7].
The keypad will display the current call-forward off
sequence.
Call Forward Off
#61#_
Press

2. Using the numeric keys, enter all the digits of the
call forward off sequence.
You can change a single digit by scrolling the cursor
left [] and right []. For special characters (eg. , =
pause, * or # etc), use the [] and [] keys.
3. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Comms > Remote Access >

User RAS PIN

Reserved for future use
30
0-9 OK to SAVE
MENU 5-1-7
0-9 OK to SAVE
MENU 5-3-8

Email Reporting

In addition to Back to Base monitoring you can also
configure your alarm system to send selected reports to an
email address of your choice. To activate email reporting,
simply enter the email address in MENU 5-5-8 and then
select the required report types in MENU 5-5-9.
The Site Name in MENU 7-7-7 is used in the email subject
line when email reporting. You should also program this
name to make it easier to identify email sent by your alarm
system.
To cancel email reporting simply remove the email address
by going to MENU 5-5-8 and then pressing the [OFF] key
followed by the [OK] key.
Currently email reporting functionality is only
i
available for panels located in Australia.
Note
Comms > MyAlarm >

Email Address

This menu allows the master user to program an email
address that the system will send email reports to. A
maximum of 80 characters can be used to program the
email address.
1. Enter your Master PIN + [MENU].
2. Enter [5] + [5] + [8] + [OK].
The keypad will display the current email address.
Email Address
_
Press

3. Use the numeric, [0] to [9], [] and [] keys to enter
or change the email address as required.
At any time you can use the [] and [] keys to scroll
through the complete list of available characters.
To clear all characters from the cursor position to the
right, press the [OFF] key.
4. When the email address is complete, press [OK] to
save and exit, or press [MENU] to exit without saving.
To stop email reporting simply remove the email
address or disable all of the email options in MENU 5-5-
9.
When entering an email address the @ symbol is
i
represented on the keypad display as
Note
To enter this character press the 1 key repeatedly until
the symbol appears in the display.
Bosch Security Systems 04/12 BLCC600U
MENU 5-5-8
OK to SAVE
.