Dryer Care - Kenmore W10034880B User Instructions

Use thedryer r ack todryitems such assweaters andpillows
without tumbling. The drum turns, b uttherack does notmove.
Ifyourmodel does nothave a dryer r ack, y oumay beable to
purchase one. T ofindoutwhether your m odel allows d ryer r ack
usage a nd toobtain information onordering, please r efer t othe
back page ofthismanual orcontact thedealer from whom you
purchased yourdryer.
NOTE: You must r emove dryer r ack fornormal tumbling. Donot
useautomatic cycles w iththedryer r ack.
TUMBLE FREE
TM
Non-Heated Dryer Rack
Use with 29" (73.7 cm) wide dryers. Air circulates in a
concentrated pattern over and around clothes to allow efficient
and uniform drying.
To use the dryer rack:
1. 29" (73.7 cm) Wide Dryer
Slide rear pegs into the dimples on the back wall of the dryer.
Lower the front legs to rest on the dryer opening.
27" (69 cm) Wide Dryer
Do not remove lint screen. Slide dryer rack over the bottom of
the dryer door opening. Push down to secure it on the frame.
2. Put wet items on the rack. Leave space between items so air
can reach all surfaces. Do not allow items to hang over the
edge of the rack. Close the door.
3. Select cycle and temperature to match the fabrics in your
load. Items containing foam, rubber, or plastic must be dried
on a clothesline or by using an air cycle. Refer to the following
table.
TUMBLE FREE
TM
Heated Dryer Rack
Use with 27" (69 cm) wide dryers. Air circulates in a concentrated
pattern over, under and through clothes, significantly reducing
drying time.
4. Start the dryer. Reset time to complete drying, if needed.
Rack Dry Cycle Temp Time
Washable wool items (block Timed Low 20 min.
to shape and lay flat on rack) Dry
Stuffed toys or pillows (cotton Timed Low 20 min.
or polyester fiber filled) Dry
Stuffed toys/pillows (foam Air None 20 - 50
rubber filled) (no heat) min.
DRYER CARE
Keep dryer area clear and free from items that would obstruct the
flow of combustion and ventilation air.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
Every Load Cleaning
Style 1:
1. The lint screen is located on top of the dryer. Pull the lint
screen toward you. Roll lint off the screen with your fingers.
Do not rinse or wash screen to remove lint. Wet lint is hard to
remove.
2. Push the lint screen firmly back into place.
Style 2:
1. The lint screen is located in the door of the dryer. Pull the lint
screen straight up. Roll lint off the screen with your fingers.
Do not rinse or wash screen to remove lint. Wet lint is hard to
remove.
Cb;s s :g khe Lint s
Clean lint screen before each load. A screen blocked by lint can
increase drying time.
IMPORTANT:
• Do not run the dryer with the lint screen loose, damaged,
blocked or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
• If lint falls off the screen into the dryer during removal, check
the exhaust hood and remove the lint. 2. Push the lint screen firmly back into place.
6