1. Manuals
  2. Brands
  3. NEC Manuals
  4. Chassis
  5. FlexATX Chassis
  6. Disassembly manual

NEC FlexATX Chassis Disassembly Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
FlexATX Chassis
Disassembly Manual

Advertisement

Table of Contents
loading

Summary of Contents for NEC FlexATX Chassis

  • Page 1 FlexATX Chassis Disassembly Manual...

  • Page 2: Required Tools

    Philips screwdriver Disassembly Instructions This document contains step-by-step disassembly instructions for the FlexATX Chassis. The instructions are clarified by images of the part that is being removed or disassembled. Furthermore, the screws that are removed are shown next to the image of the parts themselves.

  • Page 3: Opening The Chassis

    Opening the Chassis To open the chassis: 1. Remove the thumbscrews shown on the rear of the chassis. Fig. 1: Removing the thumbscrews 2. Slide the cover of the chassis towards the back of the system and than lift it away. Fig.

  • Page 4: Removing The Fdd

    Fig. 3: Removing the front panel Note Be careful not to damage the switches and LEDs board when pulling. Removing the 3.5" / 5.25" Bay Assembly To remove the 3.5" and 5.25" bay assembly first open the chassis (see Opening the Chassis), then remove the front panel (see Removing the Front Panel) and follow the next steps: 1.

  • Page 5: Removing The Hdd

    Fig. 5: Removing the FDD from its bay Removing the CD/DVD-ROM Drive To remove the CD/DVD-ROM drive, first open the chassis (see Opening the Chassis), then remove the front panel (see Removing the Front Panel) and then remove the 3.5" / 5.25" bay assembly (see Removing the 3.5"...

  • Page 6: Removing The Front Usb Panel

    Fig. 7: Freeing the hard disk drive bay 3. Slide the hard disk drive bay sidewise to free it from the latches on the bottom of the chassis. Fig. 8: Latches on the bottom of the chassis 4. Remove the screws that hold the hard disk drive to its bay.

  • Page 7: Removing The Power Supply

    3. Carefully pull away the USB panel and attached cables. Removing the Power Supply To remove the power supply, first open the chassis (see Opening the Chassis) and remove the 3.5" / 5.25" bay assembly (see Removing the 3.5" / 5.25" Bay Assembly). When this is done perform the next operations: 1.

  • Page 8: Removing The Motherboard

    Opening the Chassis), and follow these steps: 1. Disconnect all cables from the card to be removed. 2. Remove the one screw holding the card in place. Fig. 13: Removing add-on cards 3. Carefully extract the card from its slot and from the system.

Table of Contents