Sony VPL-S900U Service Manual page 12

Location and Function of Controls
!£ Speakers
!¢ Control panel
For details, see "Control panel" on page 11 (EN).
!∞ Lens hood
How to use the carrying handle
Pull up the handle from the projector for carrying.
How to attach the front cover
Attach the front cover on the front cabinet by
stretching out both right and left sides on the front
cover.
Notes
• Do not plug or turn on the projector when the front
cover is attached.
• Do not hold the front cover when you carry the
projector.
10
(EN)
How to remove the front cover
Remove the front cover from the front cabinet by
stretching out both right and left sides on the front
cover.
How to install the Remote Commander in
the front cover
Install the Remote Commander in the back of the front
cover and fix it with the velcro tapes. When housing
the Remote Commander, make sure that the infrared
transmitter faces outside and rear faces upwards.
Note
Set the COMMAND ON/OFF switch on the Remote
Commander to OFF before installing the Remote
Commander.
How to use the adjusters
While lifting the projector, adjust the height so that the
projector becomes level.
There are one adjuster at the front and two at the rear
of the projector.
As for the front adjuster, press the front adjuster button
while lifting the projector to adjust the height. Turn the
front adjuster for fine adjustment.
Front adjuster button
Control panel
LAMP/COVER TEMP/FAN
!¡
0
LIGHT
9
8
PATTERN
7
APA
6
RESET
1 I / u (on / standby) key
Turns on and off the projector when the projector is in
the standby mode. The ON indicator lights in green
when the power is turned on.
When turning off the power, press the I / u key
twice following the message on the screen, or press
and hold the key for about one second.
For details on steps for turning off the power, see "To turn off
the power" on page 24 (EN).
2 INPUT key
Selects the input signal. Each time you press the key,
the input signal switches as follows (When the RGB
IN/OUT select switch is set to OUT, you cannot select
INPUT B.):
As for the rear adjusters, turn them for adjustment.
To lower To raise
the projector the projector
Notes
• Be careful not to let the projector down on your fingers.
• Do not push hard on the top of the projector with the
adjusters out.
• Do not force the rear adjusters when you turn them.
Using too much force may result in damage.
POWER
STANDBY SAVING ON
1
+ I / u
VOLUME
2
–
INPUT
3
V MENU
B b
4
v
5
ENTER
n VIDEO/AUDIO IN n S VIDEO/AUDIO IN
INPUT B N INPUT A N
Note on the VPL-S900E model
The optional IFB-X600E Interface Board is required
for VIDEO IN and AUDIO IN jacks.
3 MENU key
Displays the on-screen menu. Press again to clear the
menu.
4 Arrow keys (V/v/B/b)
Used to select the menu or to make various
adjustments.
(Continued)
11
(EN)