4.1.3 Operation tested Access point products
The Access points that have been evaluated with the TM-P60 with Peeler are in the following
table..
Vendor
Symbol
Symbol
Vender
Cisco
4.2 About the Battery Remaining Amount
4.2.1 The battery remaining amount
This printer has a battery to supply power. The battery has four statuses:
Battery Status
Level H (High)
Level M
(Medium)
Level L (low)
Level S (Serious)
*When an AC adapter is connected to the printer, the "battery LED condition" is always Off.
4.2.2 The method to confirm the battery status
The battery status can be confirmed by every control method.
4.2.2.1 OPOS
In OPOS, the battery status can be confirmed by Direct I/O method
"PTR_DI_GET_BATTERY_STATUS." This information is described in the manual "Application
Developement Guide POS printer (TM Series): (4.3 StatusUpdateEvent regarding Battery Status.)"
This manual is installed with OPOS.
4-2 Application Development Information
Model
A/P firmware
AP-4121-1150-US
0.252-13
AP-4131-1050-WW
0.350-33
Model
Software Ver.
Air-AP1120B-A-K9
12.2 (13)JA1
The battery
LED condition
Description
Off
The remaining battery charge is between 100% and approximately
50% when the amount of difference between the full battery and
level L is 100%.
Flashing
The remaining battery charge is between approximately 50% and
level L when the amount of difference between the full battery and
level L is 100%.
On
The battery needs to be replaced or recharged because the
remaining battery charge is low.
On
The printer will not operate because the remaining battery charge
is too low.
RF firmware
V2.51-08
F3.10-04
Boot ver.
12.2(8)JA
Power Managiment
funtion with TM-P60
Impossible
Possible
Power Managiment
funtion with TM-P60
Impossible
Rev. B