Brother MFC-9130CW Service Manual page 52

Error
Problem
codes
050B When the temperature of the
center thermistor of the fuser unit
is lower than the idle
temperature, the side thermistor
of the fuser unit detected a
temperature higher than the
specified value.
050C When the temperature of the
center thermistor of the fuser unit
is higher than the idle
temperature, the side thermistor
of the fuser unit detected a
temperature lower than the
specified value.
050D ---
050F ---
0700 ---
0800 Error occurred in the internal
temperature sensor.
0900 Machine detected that supplied
power was unstable.
0A01 ---
0A02 The main fan failure was
detected.
0B01 Error in the high-voltage power
supply PCB ASSY while the
machine is in operation.
0B02 Error in the high-voltage power
supply PCB ASSY in the ready
state.
0C00 Error occurred in the density
sensor.
0D01 ---
0D02 ---
0D03 ---
0D04 ---
0E00 ---
Refer Error
to: codes
2-36 1001 ---
1002 ---
1003 The registration mark L PCB is
dirty and cannot normally receive
reflected light.
2-36 1004 The registration mark R PCB is
dirty and cannot normally receive
reflected light.
1100 ---
1300 ---
1400 ---
1C00 ---
1D01 Communication error occurred in
the LED ASSY (Black).
2-37
1D02 Communication error occurred in
the LED ASSY (Yellow).
2-37
1D03 Communication error occurred in
the LED ASSY (Magenta).
2-38 1D04 Communication error occurred in
the LED ASSY (Cyan).
2-38 1E01 Access is unavailable between
the main PCB and LED control
PCB.
2-38 1E02 Read/Write is unavailable
between the main PCB and LED
control PCB.
2-39 2001 ---
2002 ---
2003 ---
2004 ---
2005 ---
2006 ---
2101 ---
2-13
Problem
Confidential
Refer
to:
2-39
2-39
2-40
2-40
2-40
2-40
2-41
2-41