Troubleshooting - Panasonic W62P Basic Manual

Cdma 1x
Table of Contents

Advertisement

T
roubleshooting
Symptom
The phone does
not turn on.
I can't make
calls.
I can't receive
calls.
Nothing
happens when I
press the keys.
The phone
emits a
warning tone,
and turns off.
The phone
answers calls
automatically.
I can't hear
the caller.
If the battery level is very low, when the phone is turned on, "Now loading..." is
88
shown on the display, and after a while display disappear.
What to check
Is the battery pack
installed correctly?
Is the battery pack
charged?
Are you holding down
h for at least 1.5
seconds?
Is
(Out of Range)
on the display?
Did you input the area
code?
Is the phone turned
on?
Did you press d ?
Is Emission OFF
turned on?
Is
(Out of Range)
on the display?
Is the phone turned
on?
Is Emission OFF
turned on?
Is the phone turned
on?
Battery pack power is
low.
Is Easy Voice Memo
turned on?
Is Drive Mode turned
on?
Is the earpiece volume
level too low?
Is the earpiece
covered with your ear?
What to do
Correctly install the battery pack.
Charge the battery pack .
Hold down h for at least 1.5
seconds to turn on the phone.
Wait until you are in a location
where
is not displayed before
trying to make a call.
When making a call to regular
phones, you need to input the area
code.
Hold down h for at least 1.5
seconds to turn on the phone.
After inputting the phone number,
press d to dial it.
Turn off Emission OFF.
Move to a location where
on the display.
Hold down h for at least 1.5
seconds to turn on the phone.
Turn off Emission OFF.
Hold down h for at least 1.5
seconds to turn on the phone.
Charge the battery pack.
Hold down r for about one
second to turn off Easy Voice Memo.
Hold down > for about one
second to turn off Drive Mode.
During a call, press Z to increase
earpiece volume.
Make sure to place the earpiece to
the center of your ear.
Page
P.10
P.12
P.12
P.25
P.12
P.25
is not
P.12
P.12
P.12
P.10
P.33
P.4
P.32

Advertisement

Table of Contents
loading

Table of Contents