Yamaha MT09 Owner's Manual page 29

Right
1. Start/Engine stop switch "
2. Drive mode switch "MODE"
3. Hazard switch " "
Pass switch " "
Press this switch to flash the headlight.
Dimmer switch " / "
Set this switch to " " for the high
beam and to " " for the low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
INSTRUMENT AND CONTROL FUNCTIONS
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
1
Horn switch "
Press this switch to sound the horn.
2
Start/Engine stop switch "
3
To crank the engine with the starter,
set this switch to "
/ / "
the " " side of the switch. See page
5-1 for starting instructions prior to
starting the engine.
EAU12351
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
EAU12401
The engine trouble warning light will
come on when the key is turned to
"ON" and the start switch is pushed,
EAU12461
"
but this does not indicate a malfunc-
tion.
". When
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
EAU12501
" turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
EAU54211 when your vehicle is stopped where it
/ / "
might be a traffic hazard.
", and then push
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
" to stop the en-
tery may discharge.
Drive mode switch "MODE"
EAU41701
Do not change the D-mode while the
vehicle is moving.
Using this switch changes the drive
mode to "STD", "A", or "B" in the fol-
lowing order:
STD → A → B → STD
3-14
WARNING
EAU12734
" posi-
3
ECA10062
EAU47496
EWA15341