Makita 2702x1 Instruction Manual page 20

Table insert
(Part No. 317060.8
for Model
2702)
(Part No.
3 1 70614
for Model
2703)
When cutting grooves 5/16", 3/8", 7/16"
or 1/2" use this table insert instead of the
standard table insert.
To install the dado head set, proceed as follows:
0
Turn the tool off and unplug it before installing.
@
Remove the blade guard with the spreader.
@
Install the dado head set with the teeth pointing down at the front of the table.
@
Use the chart below to select the proper cutters to obtain the various cutting widths.
1 / 6 1 / 1 6
Inner Outside Outside
flange Ring cutter
Spindle
cutter cutter
cutter
CAUTION:
For a 1/8" cut width, the outside cutter is assembled to the spindle in the same manner
The outer flange or the dado outer flange must be used for each cut width.
The hex nut alone must not be used to secure the dado
on
to the spindle.
as the saw blade.
20