Cylinder Head Removal/Installation - Replacement Of Cylinder Head Gasket - Husqvarna NUDA 900 R 2012 Workshop Manual

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
2
3
4
3
2
4
5
4
1
3
2
Workshop Manual Ed. 11-2011
CYLINDER HEAD REMOVAL/DISASSEMBLY

Cylinder head removal/installation - replacement of cylinder head gasket

- Remove the camshafts, timing chain sliders as described in the relevant
paragraphs.
Removal:
- Unscrew the screws (1).
- Unscrew the screws (2).
- Remove the cylinder head (3), release the gasket to be replaced (4) tapping
it lightly if needed.
1
H10338
Installation:
- Clean cylinder head and engine crankcase sealing surfaces and fit a new
gasket (4).
- Fit the head (3), paying attention to the head-crankcase coupling by means
of the centring pins (5).
- Tighten the screws (1) and (2) manually.
Tighten the screws (2) according to the indicated order and according to what
1
is specified in the relevant chapter.
5
- Tighten the screws (1) according to what is specified in the relevant chapter.
H10339
NOTE: Always replace the screws (2) and the gasket (4) during reassembly.
5
6
H10340
F2.12