Configure The Other Controller; Add The Newly Configured Array To Navigator - Hitachi AMS 2500 Getting Started Manual

To use host groups that already exist:
• Select Use existing host groups.
• Use the Host Group drop-down list to select a host group.
j. Click Next.
k. Review the information on the next page appears and click Next.
l. Click through the confirmation pages to verify your selections. If you
need to change a selection, click the Back key until you return to the
desired page. Then make your changes and click Next to return to
the final confirmation page.
m. Click Confirm to commit your selections.
n. The next page confirms that the Create & Map Volume Wizard
completed successfully. To create additional RAID groups, logical
units, and host groups, click Create & Map More LU and repeat this
procedure. Otherwise, click Finish.

14. Configure the Other Controller

If you the connected the management console directly to one of the
controller's management ports, perform the following procedure.
Otherwise, skip to Step
2 on page
a. Connect the console to the management port of the other controller
and repeat the Navigator 2 procedure, starting with Step
Arrays on page
b. This time, follow the instructions in that step for launching the Add
Array wizard manually and, when entering settings in fields, be sure
to enter them in the field for the management port you have not yet
configured.
c. When you finish, proceed to Step
Array to Navigator 2 on page

15. Add the Newly Configured Array to Navigator 2

After you configure both controllers, perform the following procedure to add
the newly configured storage unit to Navigator 2.
a. If the Arrays page is not displayed, click Arrays in the left pane.
b. From the Arrays page, check the storage unit you just configured
under the Array Name column.
c. Click Remove Array to remove the selected base unit from the
Arrays area.
d. When the message indicates that the base unit was removed
successfully, click Close to remove the message.
e. From the Arrays page, click Add Array to run the Array wizard.
f. Click Next at the first page.
g. When the Search Array page appears (see
enter the IP address for each controller, which you recorded in
Table 1-4 on page
15. Add the Newly Configured Array to Navigator
27.
16.
1-30.
Hitachi AMS 2500 Getting Started Guide
15. Add the Newly Configured
27.
Figure 1-25 on page
12. Add
28),
27