Turning Off; Setting The Video Communication System To Standby Mode - Sony PCS-TL50 Operating Instructions Manual

Notes
• When you turn on the power of the Video Communication System for the first time
after installation, the setup wizard will appear after the self-diagnosis is completed.
Set up your system following the wizard.
For setups using the wizard, see "Setting Up the System for the First Time
— Initial Setup Wizard" on page 31.
• Used with an optional device especially designed for use with this system, such as the
Data Solution Box or ISDN Unit, for the first time, the Video Communication System
may automatically upgrade the software of the connected device. While the upgrading
message is displayed, be sure not to turn off the Video Communication System. Doing
so may cause malfunction of the system. System malfunction may also occur when a
system power-off has been caused by an accidental problem such as a power
interruption during upgrading. If connection of the Data Solution Box or ISDN Unit
to the Video Communication System is not re-established even after the system power
is recovered, consult a Sony dealer.

Turning Off

1
Press the
one second to turn the system off.
The message "The power will turn off. Please wait." appears on the display.
Then the system will be turned off.
2
Turn off the power of other equipment used for the videoconference.
Note
Turn the power of the system off when the system will not be used for an extended
period. While the power is off, you cannot receive a call from a remote party.

Setting the Video Communication System to Standby Mode

1
Press the
The message "Turn the display off, and set to standby mode?" appears on the
display.
2
Press the B or b button on the Remote Commander to select OK, and press
the ENTER button.
The Video Communication System enters standby mode.
You can receive a call from a remote party in the standby mode.
28
Turning the System On/Off
1 (power) switch on the right side of the system for more than
? / 1 button on the Remote Commander.