Setting The Audio Delay Level-Audio Delay; Memorizing The Volume Level For Each Source-One Touch Op; Selecting The Source For Hdmi Terminal And Component Video Jacks-Hdmi Select/Cmpnt Select; Selecting The Output Video Signals-Video Output - JVC RX-D401S Instructions Manual

Setting the Audio delay level
—AUDIO DELAY
Synchronization between audio and video reproduction can be
possibly disturbed because video signal decoding is time-
consuming compared to the audio signal decoding.
On this setting, you can correct synchronization between video
and audio signals by delaying the audio signal timing.
Adjustable range: OFF and 10 ms to 100 ms (in 10 ms intervals)
>
Initial setting: ADELAY OFF
Memorizing the volume level for each
source—ONE TOUCH OP
This receiver memorizes some settings separately for each
source. In addition, you can store the volume level for each source
with the other memorized settings (see page 17).
• This receiver memorizes the volume level
– when you turn off the power, and
– when you change the source.
< >
ONE TOUCH ON
Select to store the volume level separately for each
source. (The ONE TOUCH OPERATION indicator lights
up on the display.)
< >
ONE TOUCH OFF
Select this not to store the volume level.
<
Initial setting: ONE TOUCH
To recall the volume level
With the ONE TOUCH OPERATION indicator lit, the volume level
for the currently selected source is recalled when the source is
selected.
To cancel the One Touch Operation
Set One Touch Operation to "ONE TOUCH
ONE TOUCH OPERATION indicator goes off from the display.
26
>
OFF
< >
OFF " so that the
Selecting the source for HDMI
terminal and COMPONENT VIDEO
jacks—HDMI SELECT/CMPNT SELECT
When you connect a VCR or DBS to the "VCR (DBS) IN" terminal
in HDMI terminal or COMPONENT VIDEO jacks on the rear of the
receiver, you need to select either "VCR" or "DBS" according to
the component you connect.
If you have not selected appropriate source, you cannot view the
playback picture on the TV.
For the HDMI terminal:
< >
HDMI VCR Select this when assigning the HDMI
terminal for a VCR.
< >
HDMI DBS Select this when assigning the HDMI
terminal for a DBS.
< >
Initial setting: HDMI VCR
For the COMPONENT VIDEO jacks:
< >
CMPNT VCR Select this when assigning the
COMPONENT VIDEO jacks for a VCR.
< >
CMPNT DBS Select this when assigning the
COMPONENT VIDEO jacks for a DBS.
<
Initial setting: CMPNT VCR
Selecting the output video signals
—VIDEO OUTPUT
When you connect your TV and this receiver with the HDMI cable,
<
set this setting to "VIDEO HDMI
With this setting, this receiver converts incoming composite video,
S-video, and component video signals from video components
and transmits the converted signals through the HDMI cable.
< >
VIDEO HDMI
Select this when connecting a TV to the HDMI terminal.
< >
VIDEO OTHER
Select this when connecting a TV with a video jack(s)
other than the HDMI terminal.
<
Initial setting: VIDEO HDMI
NOTE
<
When selecting "VIDEO HDMI
control system (see page 38) may not operate properly. In this
case, do not make the AV COMPU LINK connection.
>
>
."
>
>
," the AV COMPU LINK remote