Laser Radiation - Makita LH1200FL Instruction Manual

Lighting up the lamps
1
012183
Push the upper position of the switch for turning on the
light and the lower position for off.
CAUTION:
Do not look in the light or see the source of light directly.
•
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
Laser beam action
1
012184
CAUTION:

LASER RADIATION

•
Do not stare into beam.
To turn on the laser beam, press the upper position (I) of
the switch. To turn off the laser beam, press the lower
position (0) of the switch.
Adjusting the up and down of top table
012187
To adjust the up and down of top table, loosen two levers
by turning counterclockwise and then raise or lower the
top table. Tighten these levers firmly after the
adjustment.
1. Lamp
1. Switch for laser
1. Lever
1
WARNING:
Position the top table at the topmost position when
•
using the tool in the miter saw mode and at the
desired position when using in the table saw mode
(bench mode).
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing saw blade
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the blade.
Use only the Makita socket wrench provided to
•
install or remove the blade. Failure to do so may
result in overtightening or insufficient tightening of
the hex bolt. This could cause an injury.
Secure the top table at the topmost position.
Lock the handle in the raised position by pushing in the
stopper pin.
012188
5
1
2
012189
Then use the socket wrench to loosen the hex bolt
holding the center cover by turning it counterclockwise.
Raise the lower blade guard A and center cover while
pushing the lever nearby the handle to the left.
8
1. Stopper pin
1
1. Lower blade
guard A
4
2. Lower blade
guard B
3 3. Top table
4. Motor housing
5. Handle