Troubleshooting - Black & Decker Li4000 Instruction Manual

Problem
• Battery will not charge.
• Tool will not drill.
• Screws stripping.
• Screws not fully seated. • Torque adjustment collar
• Screw holder not holding • Screw is non-ferrous.
screw.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACk+DECkER help line at
1-800-544-6986.
AcceSSoRIeS
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNING:
The use of any accessory not recommended for use with this tool could
be hazardous.
tHe RBRc™ SeAl
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
lithium-ion battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid
by BLACk+DECkER. In some areas, it is illegal to place spent lithium-
ion batteries in the trash or municipal solid waste stream and the RBRC
program provides an environmentally conscious alternative.
RBRC in cooperation with BLACk+DECkER and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent lithium-ion
batteries. Help protect our environment and conserve natural resources by returning the
tool to an authorized BLACk+DECkER service center for recycling. You may also contact
your local recycling center for information on where to drop off the spent battery, or call
1-800-8-BAtteRy.

troubleshooting

Possible cause
• Charger not plugged into
a working outlet.
• Surrounding air temperature
too hot or too cold.
• Torque adjustment collar in
wrong position.
• Torque adjustment collar
setting too high.
setting too low.
11
Possible Solution
• Plug charger into a
working outlet. Refer to
"Important Charging
Notes" for more details.
• Check current at
receptacle by plugging in
a lamp or other appliance.
• Check to see if
receptacle is connected to
a light switch which turns
power off when you turn
out the lights.
• Move charger and tool
to a surrounding air
temperature of above 40
degree F (4,5°C) or below
105 degree F (+40,5°C).
• Move collar position to
largest screw icon.
• Move collar position to
a smaller screw icon.
• Move collar position to
a larger screw icon.
• Use ferrous screw.