Removing The Rear Wheel; Checking The Rear Wheel; Adjusting The Rear Wheel Static Balance; Installing The Rear Wheel (Rear Brake Disc) - Yamaha 2010 XMAX YP125R Service Manual

EAS28760

REMOVING THE REAR WHEEL

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
TIP
Place the vehicle on the centerstand so that the
rear wheel is elevated. Also, place a suitable
stand under the engine.
EAS22090

CHECKING THE REAR WHEEL

1. Check:
• Tire
• Rear wheel
Damage/wear → Replace.
Refer to "CHECKING THE TIRES" on page
3-39 and "CHECKING THE WHEELS" on
page 3-41.
2. Measure:
• Radial wheel runout
• Lateral wheel runout
Refer to "CHECKING THE FRONT WHEEL"
on page 4-11.
Radial wheel runout limit
1.0 mm (0.04 in)
Lateral wheel runout limit
0.5 mm (0.02 in)
EAS22150
ADJUSTING THE REAR WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc installed.
1. Adjust:
• Rear wheel static balance
Refer to "ADJUSTING THE FRONT WHEEL
STATIC BALANCE" on page 4-12.
EAS28770
INSTALLING THE REAR WHEEL (REAR
BRAKE DISC)
1. Install:
• Rear brake disc
Rear brake disc bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
LOCTITE®
TIP
Tighten the brake disc bolts in stages and in a
crisscross pattern.
2. Check:
• Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-37.
3. Install:
• Rear fender
• Air filter case mounting bolts
Air filter case mounting bolt
9 Nm (0.9 m·kgf, 6.5 ft·lbf)
LOCTITE®
TIP
Place the rear fender between the air filter case
and the crankcase, and then install the air filter
case mounting bolts.
4-16
REAR WHEEL