Table of Contents
Advertisement
7. Mobile Rack Installation
Usually, the unit comes with one hard-disk drive installed in compartment HD 1, which is
default-configured as a master. The jumper settings configuration of the installed hard-disk drives for
the unit and compatible drives which can be used with this unit are listed in the table below. To install
a hard-disk drive in compartment HD 2, please take the following steps.
The jumper settings of hard-disk drives for the system
IDE 1
IDE 2
Location
Compartment HD 1
Compartment HD 2
1. Make sure that the key unlocked.
2. Pull the active-handle outward to remove the carrier body away from
the mobile rack
3. Slide the top cover backward and remove.
4. Setting the jumper of your hard-disk drive. The way to set the jumper
of the drive varies between manufacturers; please refer to the
instructions on the drive to set the jumpers in the master position.
56
Jumper
Master
Master
Advertisement
Table of Contents
