Makita LH1040 Instruction Manual page 9

Lighting up the lamps
For Model LH1040F only
1
005541
Push the upper position of the switch for turning on the
light and the lower position for off.
CAUTION:
Do not look in the light or see the source of light
•
directly.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
Adjusting the level of top table
012648
To adjust the level of top table, loosen two levers by
turning counterclockwise and then raise or lower the top
table. Tighten these levers firmly after the adjustment.
WARNING:
Position the top table at the topmost position when
•
using the tool in the miter saw mode and at the
desired position when using in the table saw mode
(bench mode).
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
1. Lamps
1. Lever
1
Installing or removing saw blade
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the blade.
Use only the Makita socket wrench provided to
•
install or remove the blade. Failure to do so may
result in overtightening or insufficient tightening of
the hex bolt. This could cause an injury.
Secure the top table at the topmost position.
Lock the handle in the raised position by pushing in the
stopper pin.
012646
To remove the blade, first loosen the clamping screw so
that the lower blade guard B is lowered as shown in the
figure.
6
1
2
3
012647
Then use the socket wrench to loosen the hex bolt
holding the center cover by turning it counterclockwise.
Raise the lower blade guard A and center cover while
pushing the lever nearby the handle to the left.
3
2
005545
Press the shaft lock to lock the spindle, use the socket
wrench to loosen the hex bolt clockwise. Then remove
the hex bolt, outer flange and blade.
9
1. Stopper pin
1
1. Lower blade
guard A
5
2. Lower blade
guard B
3. Clamping screw
4
4. Top table
5. Motor housing
6. Handle
1. Center cover
2. Socket wrench
3. Hex bolt
4. Blade guard A
4
1