Operations (Step 3 Setting Using the V.Networks Controller)
3-5 Image Quality Setting (Continued)
Image Quality Setting
Item
Distribution Control
OFF
ON
WB
R-B
Mg-G
Color Level
Enhance Level
Pedestal Level
60
Set the maximum transmission control.
Setting of compression level is possible when this is set to "OFF",
and images will be sent out at the specified compression level.
The smaller the value, the lower the compression level and hence
a higher image quality. However, data volume will also increase.
Set Value: 1 to 7
Setting of bit rate is possible when this is set to "ON", and the
compression level of images will be automatically adjusted ac-
cording to the specified bit rate before they are sent out.
Set value: 32 kbps to 8 Mbps
Note
• It will be necessary to establish connection again upon
setting to enable display at the correct frame rate.
Determines the setting of the white balance adjustment
feature.White balance can be adjusted for lighting conditions
within a color temperature range of 2,300 K to 10,000 K.
ATW : Auto-Tracking White Balance mode. Adjusts the white
balance automatically according to the color tempera-
ture of the lighting.
During ATW setting, hue adjustment for the R-gain and
B-gain items will be disabled.
AWC : If AWC is selected from the pull-down menu, the Auto
White Control mode will be activated for white balance
adjustment. Switching from the ATW to AWC mode will
take at least 15 seconds.
Adjusts the phases of R (Red) and B (Blue) under AWC mode.
To enhance blue
To enhance red
Setting values
Adjusts the phases of M (Magenta) and G (Green) under AWC
mode.
To enhance green
To enhance magenta : Increase the value.
Setting values
Adjusts the color level of video signals.
To lighten the color † Decrease the value
To darken the color † Increase the value
Set value: -5 to 5
Sets the contour enhancement which controls the sharpness
of video signals.
To soften the picture
To sharpen the picture † Increase the value
Set value: -5 to 5
Sets the pedestal level (black level) of video signals.
To darken the picture
To brighten the picture † Increase the value
Set value: -5 to 5
Function/Set Value
: Decrease the value.
: Increase the value.
: 0 to 100
: Decrease the value.
: 0 to 100
† Decrease the value
† Decrease the value
Initial Value
OFF
2
—
ATW
56
30
0
0
0