Appendix 2 Port Map - HIKVISION Network Camera User Manual

User Manual of Network Camera
Note: The following setting is about TP-LINK router (TL-R410), which is maybe distinct from other
router's setting.
1. Firstly, select the router's WAN connection Type. As the following Figure shows:
2. Set the "network parameter" of the router as the below figure. The setting includes subnet
mask and gateway.
3. Set the port map in the virtual severs of Forwarding. By default, camera uses port 80, 8000, 554
and 8200. You can change these ports value with IE or client software.
The following figure gives the illustration. One camera's ports are 80, 8000, 554, 8200 and its IP
address is 192.168.1.23. The other camera's ports are 81, 8001, 555, 8201 and IP is 192.168.1.24.
Afterwards, enable all or TCP protocols. Enable the port map after pressing the 'Save'.
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.

Appendix 2 Port Map

42