JVC AV 20320 User Manual page 11

Step Two - Making Basic Connections
Next you will need to connect your television to an antenna or cable system. The most basic
antenna/cable connection is shown below. For more detailed connections, such as ones where
a cable box is required, see pages 13 and 14.
1) Connect an RF cable out from the wall outlet in to the RF Input on the back of the TV.
You may also wish to connect a VCR at this point. A basic stereo VCR connection is shown
below. For detailed instructions on connecting other components or a home theater system,
see pages 13 to 16.
Note: A VCR is not required to operate your television.The connection shown below is for
stereo televisions only (models AV-20320, and AV-20321 only). All others use connections
shown on pages 13 and 14.
Illustration of AV-20320
1) Connect the yellow video cable out from the VCR's Video Output, in to the TV's Video Input
jack.
2) Connect the white audio cable out from the VCR's Left Audio Output, in to the TV's Left
Audio Input Jack.
3) Connect the red audio cable out from the VCR's Right Audio Output, in to the TV's Right
Audio Input jack.
Finally, once you have finished your connections, plug the power cord into the nearest power
outlet and turn on the television.
Quick Setup 2
INPUT
OUTPUT
VIDEO—
(VHF/UHF) (VHF/UHF)
L
L/ MONO
l
AUDIO
I
R
R
INPUT
OUTPUT
AUDIO OUT
VIDEO–
L
L/ MONO
L
L
l
AUDIO
I
R
R
Proceed to Step Three
75‰
Illustration of AV-20320
AV Cables/Plugs
75Ω
(VHF/UHF) (VHF/UHF)
IN
OUT
Cable/RF connector
11