Advertisement
10. Install the A/C switch knob and the evaporator sensor.
Insert the A/C switch
button in the A/C switch
hole, then push on the
button until it clicks into
place.
With a small
flat-tip screwdriver,
carefully pry out
the A/C switch
hole cover and
discard it.
Connect the evaporator
sensor to the sensor
harness 2P connector
you freed in step 5,
then snap the connector
clip in the bracket on
the blower unit.
Insert the evaporator
sensor into the
sensor hole, then
turn it clockwise
until it clicks into place.
Remove and
discard the
sensor hole
cover.
12 of 24
Apply protective tape to the
heater control panel just
below the A/C switch hole
cover.
HEATER UNIT
LOWER CASE
FRONT
Remove the ashtray, then remove the self-tapping
screw. Remove the center console by pulling out
on the cover to release the clips, then disconnect
the connectors and the illumination bulb.
VEHICLE
HARNESS
AII 24158 (0209)
With Cigarette Lighter/Ashtray
Without Cigarette Lighter/Ashtray
Remove the center
console cover by
pulling out on the
cover to release the
clips, then disconnect
the accessory power
socket connector.
Remove the blue tape
securing the evaporator
sensor 2P connector to
the vehicle harness.
2002 American Honda Motor Co., Inc – All Rights Reserved
BLUE
TAPE
Advertisement
