Honeywell T7300F Installation Instructions Manual page 5

Installer Setup
Number
(Press
Unoccupied
Temp Key
change)
Select
Duration of 26
temporary
override.
Not used. 27 thru 29
Deadband. 30
Interstage 31
control point
(Q7300C,D
only).
Minimum on- 32
time.
Minimum off- 33
time for the
compressor.
Temperature 34
range stops in
heating.
Temperature 35
range stops in
cooling.
Not used. 36
T7300F SERIES 2000 COMMERCIAL MICROELECTRONIC CONVENTIONAL
Table 2. Thermostat Installer Setup Options (Continued).
Factory Setting
to
Display Description
3 3—Three hour
override.
—
2 Heating and cooling
setpoints can be set
no closer than 2°F
(1.1°C).
0 Disabled.
2 2-minute minimum
on- time for heating
and cooling.
4 4-minute minimum
off- time for the
compressor.
90 Highest setpoint for
heating.
45 Lowest setpoint for
cooling.
—
(Press
Display
1, 8 or 1—One hour override.
12 8—Eight hour override.
12—Twelve hour override.
— —
3 thru Heating and cooling
10 setpoints can be set no
closer than the chosen
value:
1 thru Temperature has to
12 change more than the
chosen value before the
system calls for the next
stage. (Example: 68°F
(20°C) is the heat
setpoint, 2°F (1.1°C) is
the interstage setting,
temperature is 65.5°F
(18.5°C), the second
stage turns on, brings the
temperature to 66°F
(19°C) and turns off. The
heat pump continues to
run until the setpoint is
met.)
0 or 1 No minimum on-time or
1-minute minimum on -
time for heating and
cooling.
0, 1, 2, Minimum number of
3 or 5 minutes (0 thru 5) the
compressor will be off
between calls for the
compressor.
40 to Temperature range (1°F
89 [0.6°C] increments) for
heating setpoint.
46 to Temperature range (1°F
99 [0.6°C] increments) for
cooling setpoint.
— —
5
OR HEAT PUMP THERMOSTAT
Other Choices
or key to change)
∆ ∇
Description
—
3—3°F (1.7°C)
4—4°F (2°C)
5—5°F (2.5°C)
6—6°F (3°C)
7—7°F (3.5°C)
8—8°F (4°C)
9—9°F (4.5°C)
10—10°F (5°C)
—
Actual
Setting
—
—
(Continued)
62-0125—3