2.3 Web User Interface Programming
After connecting the unit to your network, you can configure the unit's settings by accessing the Web user
interface from a PC connected to the same network. For details, see Section 4 Web User Interface
Programming.
PC
Note
•
Connect the switching hub to the unit's LAN port. The unit will not connect properly if you connect to
the unit's PC port.
•
While the unit is connected to a switching hub, you can also perform Web user interface programming
by connecting a PC to the unit's PC port.
•
You can perform Web user interface programming by connecting a PC directly to the unit without using
a switching hub or router. In this case, connect the PC to the LAN port of the unit.
Document Version 2012-07
Router
Switching
Hub
SIP Phone
Section 2 General Information on Programming
Administrator Guide
23