Explanation Of The Dip Switches; Panel Dip Switch Functions; Setting The Presser Mode - Brother LK3-B430E Mark II Service Manual

10-5. Explanation of the DIP switches

10-5-1. Operation panel DIP switches
Switch
DIPA-1
DIPA-2
DIPA-3
DIPA-4
DIPA-5
DIPA-6
DIPA-7
DIPA-8

10-5-2. Setting the presser mode

Through the combination of DIP switches A-1 and A-2 on the operation panel, presser motions can be set as
follows:
DIPA-1
DIPA-2
—
ON
—
ON
q
Presser does not automatically lift after sewing is
completed.
Two-pedal mode is available.
User program mode is available.
—
The presser does not rise automatically when a split is found.
Displays the enlargement/reduction ratio in millimeter units instead of as a percentage.
(After changing this setting, be sure to carry out the auto-clear operation by referring to
page 73.)
Enlargement of pattern size is not available.
Program number is fixed.
Pedal specifications
— Single pedal
— Single pedal
ON Two pedals
Two pedals
ON
The operation panel DIP switches q are used to
change functions which might need to be changed
depending on the sewing conditions.
NOTE:Always turn off the power before setting the
DIP switches.
The functions shown in the table below can be
changed by means of these DIP switches.
* All DIP switches are set to OFF at the time of ship-
ment.
Motion when set to ON
Raising the presser at the sewing end
Presser is raised automatically.
Presser is raised by pressing the pedal.
Presser is raised auddtomatically, then it is lowered by
pressing the pedal.
Presser is kept lifted while the pedal is pressed.
LK3-B430E Mark II
10. ELECTRIC MECHANISM
See "10-5-2. Setting the presser
mode"
68