Problem Solver - GE JCSP31 Use And Care Manual

PROBLEM
"F–AND A NUMBER
OR LETTER" FLASH
IN THE DISPLAY
DISPLAY GOES BLANK
DISPLAY FLASHES
UNABLE TO GET THE
DISPLAY TO SHOW "SF"
"LOCK DOOR" FLASHES
"LOCKED DOOR" FLASHES
DOOR WILL NOT OPEN
AFTER SELF-CLEAN CYCLE
CONTROL SIGNALS AFTER
ENTERING COOKING TIME
OR DELAY START TIME
CLOCK AND TIMER
DO NOT WORK
SURFACE UNITS NOT
FUNCTIONING PROPERLY
OVEN WILL NOT WORK
QUESTIONS?
USE THIS PROBLEM SOLVER
POSSIBLE CAUSE
• This is a function error code. Press CLEAR/OFF. Allow the oven to cool one
hour. Place the oven back into operation.
• Disconnect all power to the oven for 5 minutes and then reconnect power. If the
failure code repeats, call for service.
• The circuit breaker in your house has been tripped, or a fuse has been blown.
• Power failure. Reset the clock.
• BAKE and BROIL HI/LO must be pressed at the same time and held for
2 seconds.
• Oven door not closed after self-clean cycle is selected.
• Door is still locked and you are trying to enter an oven cooking operation.
• When the temperature has fallen below the locking temperature, the door can
be opened.
• This is reminding you to press BAKE and then enter a temperature.
• This is reminding you to enter a bake temperature after having pressed BAKE.
• This is reminding you to close the oven door so the self-clean cycle can start.
• Make sure the electrical plug is plugged into a live, properly grounded
power outlet.
• Check for power outage.
• See the Oven Control, Clock and Timer section.
• Surface units are not plugged in solidly.
• Surface unit controls are not properly set.
• The plug on the range is not completely inserted in the electrical outlet.
• The circuit breaker in your house has been tripped, or a fuse has been blown.
• The oven controls are not properly set.
(continued next page)
37