Display; Front Panel - Yamaha MT8X Operation Manual

DISPLAY

dbx Indicator
This indicator illuminates when the dbx system is on.
SYNC Indicator
This indicator illuminates when the SYNC switch is
pressed to be turned on.
Automatic Punch-in/out Indicator
This indicator displays the automatic punch-in/out
recording status.
MEMO 1 and 2 Indicators
These indicators illuminate when the respective
memory points have been set.
If the MEM0 1 button is pressed, [1] flashes three
times and then illuminates.
If the MEMO 2 button is pressed, [2] flashes three
times and then illuminates.
REPEAT Indicator
This indicator illuminates while the repeat playback is
being performed.
TAPE Indicator
This indicator illuminates when a cassette tape is
inserted. If a cassette tape has not yet been
inserted, the indicator will flash if a button for tape
running is pressed.

FRONT PANEL

12
REC Select Indicators
The indicator corresponding to the track selected by
a REC SELECT switch flashes to indicate that
recording is possible to the track. If the REC/PAUSE
button is pressed at this time, the indicator changes
from flashing to illuminating and this unit enters into
the recording standby mode.
Level Meter
The level meter displays the recording or playback
level of each track, or the signal level at the stereo
buses within a range of -20 dB - +9 dB.
Tape Counter
The tape counter is displayed by minutes and
seconds. The time displayed is as close as possible
to the actual time elapsed, but there will be a small
amount of error depending on the type of tape being
used. The range of errors are as follows:
C-46: ±13% (±1 min. 30 sec.)
C-60: ±10% (±1 min. 30 sec.)
C-90: ±13% (±3min.)
PHONES Jack
Connect headphones (8-40 ) to this jack.
PUNCH I/O Jack
When using a footswitch (sold separately) in punch-
in/out recording, connect the footswitch to this jack.
(See "PUNCH-IN/OUT RECORDING" on page 20.)
REMOTE CONTROL Jack
When using remote controller RCM1 (sold
separately) to operate the recorder, connect the
remote controller to this jack.
A view from over
the top panel.