Assembly; Mounting Rubber Feet To Base; Parts Storage - RIDGID EB4424 Owner's Manual

Assembly

NOTE: The sander is preassembled except for the
attachment of the rubber feet.

Mounting Rubber Feet To Base

Place the sander directly on the table surface.
1. From the parts bag locate the four rubber feet.
2. Place the sander on its side so the bottom of the base
is facing toward the front.
3. Locate the four holes in each corner of the base and
place one of the rubber feet in each of these holes.
4. Position sander in the upright position and apply pres-
sure in the downward position to ensure the feet are
inserted securely.
CAUTION: To reduce the risk of injury from tool
movement, the supporting surface where sander is
mounted should be examined carefully after
mounting to insure no movement during use can
result. If any tipping or walking is noticed, secure
to workbench or supporting surface before operat-
ing sander.

Parts Storage

On board storage has been provided for all washers,
spacers, drums, sleeves and hex "L" wrenches. All front
loaded parts can be protected from incidental dislodging
by lowering the table all the way down until it rests
against the base and tightening the knob.
Storage for the belt sanding assembly and table insert is
provided in the pocket on the rear of the base.
8
Rubber Feet